CNCDIY Club

Share your experience with CNCDIY's Machine
 
HomeCalendarGalleryFAQSearchMemberlistUsergroupsRegisterLog in

Share | 
 

 Corian lithophane

View previous topic View next topic Go down 
AuthorMessage
ab



Posts : 14
Join date : 2011-01-26

PostSubject: Corian lithophane   Tue May 10, 2011 6:59 am

Hi Folks,

I made this last week and thought you might be interested!

Here is the piece without a backlight


And then with the backlight!


The piece of Corian was 6mm thick and I cut it using a 60deg 2 blade V cutter in one pass (maximum of 4mm deep) at 500mm/min but there was about 1000 passes (0.25mm step over per pass). All up it took about 6 hours to cut however next time I'm going to try cutting slightly shallower and but much faster with a roughing pass. I think I should be able to knock it off in around half that time.

Cheers,

Andrew
Back to top Go down
View user profile
 
Corian lithophane
View previous topic View next topic Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
CNCDIY Club :: Experience Sharing :: Plastic and Composite Processing-
Jump to: